Titan Tool 2000XD Manual do Utilizador descarregar pdf (Página 15)

IN! THE! F I ELD!TECH N I QUES

When pinpointing a target, try drawing an “X”,

as illustrated, over where the tone is induced.

NOTE: This modern Metal Detector is referred to as a Motion Detector since it can respond to a

target only while the searchcoil is being moved over the Target

PINPOINTING

Accurate pinpointing takes practice

and is best accomplished by “X-ing”

the target area.

1. Once a buried target is indicated

by a good tone re s p o n s e ,

continue sweeping the coil over

the target in a narrowing side-

to-side pattern.

2. Take visual note of the place on

the ground where the “ b e e p ”

sounds.

3. Stop the coil directly over this spot

on the ground.

4. Now move the coil straight for-

ward and straight back towards

you a couple of times.

5. Again make visual note of the spot

on the ground at which the

“beep” sounds.

6. If needed, “X” the target at

different angles to “zero in” on

the exact spot on the ground at

which the “beep” sounds.

COIL MOVEMENT

When swinging the coil, be c a re f u l

to keep it level with the gro u n d

about one inch from the surf a c e .

Never swing the coil like a pendu-

l u m .

CORRECT

WRONG

Titan2000MANUAL.qx6 4/22/08 12:29 PM Page 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

Titan Tool 2000XD Manual do Utilizador Página 15